ME3407 MECHATRONICS LAB SYLLABUS | ANNA UNIVERSITY BE MECHANICAL & AUTOMATION ENGINEERING 7TH SEM SYLLABUS REGULATION 2008 2011 2012-2013 BELOW IS THE ANNA UNIVERSITY SEVENTH SEMESTER BE MECHANICAL AND AUTOMATION ENGINEERING DEPARTMENT SYLLABUS, TEXTBOOKS, REFERENCE BOOKS,EXAM PORTIONS,QUESTION BANK,CLASS NOTES, IMPORTANT 2 MARKS, 8 MARKS, 16 MARKS TOPICS. IT IS APPLICABLE FOR ALL STUDENTS ADMITTED IN THE YEAR 2011 2012-2013 (ANNA UNIVERSITY CHENNAI,TRICHY,MADURAI,TIRUNELVELI,COIMBATORE), 2008 REGULATION OF ANNA UNIVERSITY CHENNAI AND STUDENTS ADMITTED IN ANNA UNIVERSITY CHENNAI DURING 2009
ME3407 MECHATRONICS LABORATORY LT P C
0 0 3 2
AIM:
To know the design, modeling & analysis of basic electrical, hydraulic & pneumatic systems using
software and trainer kits.
OBJECTIVES:
1. Design and testing of the circuits such as
i) Pressure control valves ii)Flow control valves iii)Directional control valves
2. Design of circuits with logic sequence using Electro pneumatic trainer kits.
3. Simulation of basic hydraulics, pneumatic and electric circuits using software.
4. Circuits with multiple cylinder sequences in Electro pneumatic using PLC
5. Speed measurement using Inductive pickup/Proximity sensor.
6. Temperature measurement using thermocouple, thermistor and RTD
7. Servo controller interfacing i) open loop ii) closed loop
8. PID controller interfacing
9. Computer controlled relays, solenoids and DC motors
10. Study of CMM based instrumentation
11. Modeling and analysis of basic electrical, hydraulic and pneumatic systems using
12. LAB VIEW software
TOTAL : 45 PERIODS
ME3407 MECHATRONICS LABORATORY LT P C
0 0 3 2
AIM:
To know the design, modeling & analysis of basic electrical, hydraulic & pneumatic systems using
software and trainer kits.
OBJECTIVES:
1. Design and testing of the circuits such as
i) Pressure control valves ii)Flow control valves iii)Directional control valves
2. Design of circuits with logic sequence using Electro pneumatic trainer kits.
3. Simulation of basic hydraulics, pneumatic and electric circuits using software.
4. Circuits with multiple cylinder sequences in Electro pneumatic using PLC
5. Speed measurement using Inductive pickup/Proximity sensor.
6. Temperature measurement using thermocouple, thermistor and RTD
7. Servo controller interfacing i) open loop ii) closed loop
8. PID controller interfacing
9. Computer controlled relays, solenoids and DC motors
10. Study of CMM based instrumentation
11. Modeling and analysis of basic electrical, hydraulic and pneumatic systems using
12. LAB VIEW software
TOTAL : 45 PERIODS
No comments:
Post a Comment
Any doubt ??? Just throw it Here...