MF3309 CAD LABORATORY SYLLABUS | ANNA UNIVERSITY BE MANUFACTURING ENGINEERING 5TH SEMESTER SYLLABUS REGULATION 2008 2011 2012-2013 BELOW IS THE ANNA UNIVERSITY FIFTH SEMESTER BE MANUFACTURING ENGINEERING DEPARTMENT SYLLABUS, TEXTBOOKS, REFERENCE BOOKS, IT IS APPLICABLE FOR ALL STUDENTS ADMITTED IN THE YEAR 2011 2012-2013 (ANNA UNIVERSITY CHENNAI,TRICHY,MADURAI,TIRUNELVELI,COIMBATORE), 2008 REGULATION OF ANNA UNIVERSITY CHENNAI AND STUDENTS ADMITTED IN ANNA UNIVERSITY CHENNAI DURING 2009
MF3309 CAD LABORATORY L T P C
0 0 2 1
AIM:
To provide practical knowledge in Computer aided modeling and assembly
OBJECTIVE:
To impart hands on experience to students in Geometric Modeling, Assembly and
Engineering Drafting.
1. SKETCHER
Introduction- Basic sketch, Constraints – Geometry & Dimensional.
2. SOLID MODELING
Extrude, Revolve, Sweep, Loft, Datum plane creation etc.
3. SURFACE MODELING
Extrude & Revolve surfacing, Advance surfacing technique – Ruled & Loft surfacing,
Mesh of curves, Free form surfaces, Surface operations – trium, merge, intersect, etc.
4. FEATURE MANIPULATION
Copy, Edit, Pattern, Suppress, History operations etc.
5. ASSEMBLY
Constraints, Patterns, exploded Views, Interference check, creating components from
assembly, mass property calculations, BOM generations and assembly cut sections.
6. DRAFTING
Standard view, Sectional views and Detailing, BOM and Balloon creation.
TOTAL : 30 PERIODS
MF3309 CAD LABORATORY L T P C
0 0 2 1
AIM:
To provide practical knowledge in Computer aided modeling and assembly
OBJECTIVE:
To impart hands on experience to students in Geometric Modeling, Assembly and
Engineering Drafting.
1. SKETCHER
Introduction- Basic sketch, Constraints – Geometry & Dimensional.
2. SOLID MODELING
Extrude, Revolve, Sweep, Loft, Datum plane creation etc.
3. SURFACE MODELING
Extrude & Revolve surfacing, Advance surfacing technique – Ruled & Loft surfacing,
Mesh of curves, Free form surfaces, Surface operations – trium, merge, intersect, etc.
4. FEATURE MANIPULATION
Copy, Edit, Pattern, Suppress, History operations etc.
5. ASSEMBLY
Constraints, Patterns, exploded Views, Interference check, creating components from
assembly, mass property calculations, BOM generations and assembly cut sections.
6. DRAFTING
Standard view, Sectional views and Detailing, BOM and Balloon creation.
TOTAL : 30 PERIODS
No comments:
Post a Comment
Any doubt ??? Just throw it Here...