MF3308 METROLOGY LABORATORY SYLLABUS | ANNA UNIVERSITY BE MANUFACTURING ENGINEERING 5TH SEMESTER SYLLABUS REGULATION 2008 2011 2012-2013 BELOW IS THE ANNA UNIVERSITY FIFTH SEMESTER BE MANUFACTURING ENGINEERING DEPARTMENT SYLLABUS, TEXTBOOKS, REFERENCE BOOKS, IT IS APPLICABLE FOR ALL STUDENTS ADMITTED IN THE YEAR 2011 2012-2013 (ANNA UNIVERSITY CHENNAI,TRICHY,MADURAI,TIRUNELVELI,COIMBATORE), 2008 REGULATION OF ANNA UNIVERSITY CHENNAI AND STUDENTS ADMITTED IN ANNA UNIVERSITY CHENNAI DURING 2009
MF3308 METROLOGY LABORATORY L T P C
0 0 2 1
AIM:
To acquire skills in measuring basic contact and contact measuring instruments
OBJECTIVE:
To make the students understand the fundamental principles of measuring techniques
by practicing exercises on various measuring instruments.
LIST OF EXERCISES:
Contact methods:
1. Linear and Angular measurement using Autocollimator.
2. Measurement of composite error using gear tester.
3. Calibration of optical comparator and measurement of dimension
4. Determining the accuracy of electrical and optical comparator.
5. Measurement of taper angle using sine bar.
6. Measurement of various angles using Bevel Protractor.
Non-contact measurement techniques:
1. Measurement of Taper angle using Tool Makers Microscope.
2. Measurement of various elements of screw thread using Tools Makers Microscope.
3. Experiments in CMM.
TOTAL : 30 PERIODS
MF3308 METROLOGY LABORATORY L T P C
0 0 2 1
AIM:
To acquire skills in measuring basic contact and contact measuring instruments
OBJECTIVE:
To make the students understand the fundamental principles of measuring techniques
by practicing exercises on various measuring instruments.
LIST OF EXERCISES:
Contact methods:
1. Linear and Angular measurement using Autocollimator.
2. Measurement of composite error using gear tester.
3. Calibration of optical comparator and measurement of dimension
4. Determining the accuracy of electrical and optical comparator.
5. Measurement of taper angle using sine bar.
6. Measurement of various angles using Bevel Protractor.
Non-contact measurement techniques:
1. Measurement of Taper angle using Tool Makers Microscope.
2. Measurement of various elements of screw thread using Tools Makers Microscope.
3. Experiments in CMM.
TOTAL : 30 PERIODS
No comments:
Post a Comment
Any doubt ??? Just throw it Here...