AT2207 FLUID MECHANICS AND MACHINERY LAB SYLLABUS | ANNA UNIVERSITY BE AUTOMOBILE ENGINEERING 3RD SEMESTER SYLLABUS REGULATION 2008 2011-2012 BELOW IS THE ANNA UNIVERSITY THIRD SEMESTER BE AUTOMOBILE ENGINEERING DEPARTMENT SYLLABUS IT IS APPLICABLE FOR ALL STUDENTS ADMITTED IN THE YEAR 2011-2012 (ANNA UNIVERSITY CHENNAI,TRICHY,MADURAI,TIRUNELVELI,COIMBATORE), 2008 REGULATION OF ANNA UNIVERSITY CHENNAI AND STUDENTS ADMITTED IN ANNA UNIVERSITY CHENNAI DURING 2009
(Offered Automobile only) 0 0 3 2
LIST OF EXPERIMENTS
1. Determination of the Coefficient of discharge of given Orifice and Venturi meter.
2. Calculation of the rate of flow using Rota meter.
3. Determination of friction factor of given set of pipes.
4. Conducting experiments and drawing the characteristic curves of centrifugal pump/
submergible pump
31
5. Conducting experiments and drawing the characteristic curves of reciprocating
pump.
6. Conducting experiments and drawing the characteristic curves of Gear pump.
7. Conducting experiments and drawing the characteristic curves of Pelton wheel.
8. Conducting experiments and drawing the characteristics curves of Francis
turbine.
9. Conducting experiments and drawing the characteristic curves of Kaplan turbine.
10 Flow visualization experiment on the effects of sharp corner and rounded corner
and add-on devices in automobiles
11. Drag estimation on models of automobiles of different shapes
TOTAL: 45 PERIODS
LIST OF EQUIPMENTS
(for the batch of 30 students)
1. Orifice meter setup
2. Venturi meter setup
3. Rotameter setup
4. Pipe Flow analysis setup
5. Centrifugal pump/submergible pump setup
6. Reciprocating pump setup
7. Gear pump setup
8. Pelton wheel setup
9. Francis turbine setup Kaplan turbine setup
10. Wind tunnel with pressure measuring devices
No comments:
Post a Comment
Any doubt ??? Just throw it Here...